In order to print the ring sizer above, be sure that your printer is set to 100%. Make sure that you have not reduced the print size in your printer 'page setup' area. You can verify that the sizer printed correctly by measuring it with a ruler; it should measure from A to B: 3 1/2 inches long.
Once you have printed the sizer, follow these directions to find your ring size:
-
Cut out the ring sizer
-
Cut a slit for Slot "A"
-
With the numbers facing out, wrap the sizer around the finger on where the ring will be worn.
-
Pull the pointed end Tab "B" through Slot "A" until the sizer is very snug.
-
Measure your knuckle the same way following the previous steps.
-
The larger of the two numbers aligned with Slot "B" is your ring size.
-
If the measure lands between two numbers your size is a half size Ex: Between 5 and 6 ring size: 5.5. If half sizes are not available, order the next largest size.